10-year-old Fatima Jaafar Abdullah was killed in pager explosions in Lebanon.

Israel murders another kid again.

  • bad_alloc@lemmy.dbzer0.com
    link
    fedilink
    English
    arrow-up
    9
    ·
    2 months ago

    There are videos capturing lots of explosions going off simulataneously. Since pagers already can recieve messages and these devices were deeply infiltrated, they likely added a special trigger message to set them off. THis could also allow other scenarios, like only setting off one (for whatever reason).

      • bad_alloc@lemmy.dbzer0.com
        link
        fedilink
        English
        arrow-up
        3
        ·
        2 months ago

        If they can plant explosives they can 100% tap into the circuit or maybe reprogram the board. The CIA is known to be able to do this to specific devices by plucking them from the mail. Mossad could likely do their own production run and ship that to Hezbollah.

      • bloodfart@lemmy.ml
        link
        fedilink
        English
        arrow-up
        3
        ·
        2 months ago

        you really might not.

        before there were mobile phones there was analog dtmf wired telephones. they replaced pulse dialing and allowed for all kinds of additional signalling and triggering. ring a bell, operate a relay, kick people off so you could call the president, entire automated analog switching centers, you name it.

        when mobile networks came on the scene there were all sorts of additional triggers but because the (second gen? the ones that could do sms) signals were actually digital, there was a much wider array of possibilities. dtmf had a handful of frequencies it supported and if you wanted to do something more you had to basically make sure the entire network you were using could send, transport and receive those frequencies.

        now imagine instead of sixteen combinations of frequencies played at the same time you have access to thousands of possible triggers. once you have simple stuff like the basic receiving of text and lighting a led or playing one of several legally distinct jingles covered, you could do do much more. and people did. there were all kinds of things pagers could do through combinations of local interface and digital communication with a cell tower, all mediated through a handful of baseband chips on the pager pcb that could have the pins for stuff they wouldn’t be used for disconnected.

        but how would you make a pager set off an explosive?

        well, the same way you use a casio f91w wristwatch to. you use its built in functionality (the speaker when the alarm goes off) to trigger a battery that can deliver enough electricity into a resistor to heat it up enough to make your (primary) explosive detonate.

        in the case of a pager, those baseband chips have all kinds of on and off switching built in. it’s not hard to imagine that basic, out of the box functionality would include pulling a pin high when it gets “*97” or some such. now tie that pin to the base of a transistor across the positive and negative terminals of the battery and sitting against a little petn and you got yourself a remotely triggered explosive.

        you wouldn’t even need a pcb.

        there’s probably a lot of stuff thats incorrect in this reply. it’s late and this is off the dome.

      • Croquette@sh.itjust.works
        link
        fedilink
        English
        arrow-up
        1
        ·
        2 months ago

        If they can intercept the message where it isn’t encrypted, they can simply sniff the messages coming on the page and wait for their signal.

        Then, they can trigger the explosive to a specific message.

        That’s a wild guess though.